AM Autoparts
List Price:$164.95
AM Price:$126.99
You Save:$37.96
Save 23%
Free Ground Shipping
Need this part fast? Choose Next Day Air at checkout!

Part Number: AM-3948326635

FREE Shipping is standard on orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii and Alaska.

Shipping is not available to a P.O. Box, APO/FPO/DPO addresses, US Territories, or Canada for this item.

Expedited is available on checkout to the United States, excluding Alaska, Hawaii.

Final shipping costs are available at checkout.

Attention California Customers:

proposition 65 iconWARNING:  This product can expose you to chemicals including Carbon black(airborne, unbound particles of respirable size), which is known to the State of California to cause cancer.  For more information, go to www.P65Warnings.ca.gov.

10 Year Warranty

This item is backed by our 10-year warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

Please note: Any modifications to an item of any kind before contacting us will void any and all warranty coverage for this item. Please contact us before modifying the part so that we have the opportunity to correct the situation.

This part replaces:

  • OE # 50820SHJA03
  • OE # 50805S87A80
  • OE # 50810SHJA00
  • OE # 50830SHJ305
  • OE # 50806SHJA01
  • TRQ MTA32782

Vehicle Fit

  • 2005-2006 Honda Odyssey EX V6 3.5L 5 Piece Engine & Transmission Mount Kit AM Autoparts AM-3948326635
  • 2005-2006 Honda Odyssey LX V6 3.5L 5 Piece Engine & Transmission Mount Kit AM Autoparts AM-3948326635

Product Reviews

Powered by Emplifi
4.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
0
1
0
0
0
Rated 4 out of 5
Only one problem.
Four of the mounts installed without any issues. The only one I found a problem with was the Rear Engine Mount. The two mounting holes, on the drivers side of the mount, were not tapped deep enough. The bolts bottomed before the head of the bolt touched the frame. I had to fabricate a shim, 3/16 thick to put under the head of the bolt, to allow each bolt to be tightened properly without bottoming in the mount. If I had been using a power tool to tighten the bolts, I would have busted out the side of the mount. POOR QUALITY CONTROL, THEY NEED NEW INSPECTORS.
May 10, 2020
Purchased
 over 4 years ago